Having lots of device that you need to operate with limited 4pin connectors from your power supply unit can be a hassle, hence if you purchase convertors,
you might have messy cable management. Therefore, here is a cheap way to do a multi connector with only using 1 4pin molex from your power supply unit.
Remember to wear safety goggles and gloves when you are handling tools. It helps to prevent unnecessary injuries. If you are not confident or not adult enough to handle tools.
Kindly consult adults or experience tool user as I will hold no responsibilities for any injuries or damages.
BLUE PRINT
Kindly understand the diagram below before you proceed to mod.
Tools and material needed. A pair of long nose pliers, a pair of scissors, a marker, 1 x 4pin molex, a multi-connector, a flat head/Philip screw driver, marker and some lose wires.
Base on the diagram, use marker to mark out the negative polarity.
Bare wires shown above.
Place the wires accordingly on the marking of the multi-connector and fasten these wires with a pair of screwdriver.
Bare and crimp the wires on the other ends as there are to be plug to a 4pin molex.
This device is done and ready to be tested.
Now connect the 4pin molex to your power supply unit and connect all fans or even a neon tube to the multi-connector.
Turn on your power supply unit and there you have it. All in working condition.
